德恩數控：玻璃浮法成型的原理

浮法玻璃的成型原理：是讓處于高溫熔融狀態的玻璃液浮在相對密度大的金屬液表面上，受表面張力作用是玻璃具有光潔平整的表面，并在其后的冷卻硬化過程中加以保持，則能生產浮法玻璃。

The forming principle of float glass: glass is let liquid floating in high temperature molten state in the molten metal surface relative density on the surface of the glass is influenced by the surface tension effect is smooth, and to maintain the cooling hardening process followed, can float glass production.

介質的選擇：

Media choice:

1、在1050℃溫度下的密度大于玻璃。

1, at a temperature of 1050 degrees Celsius is greater than the density of glass.

2、金屬的熔點低于600℃，沸點高于1050℃，1000℃左右的蒸氣壓應盡可能低。

2, the melting point of the metal below 600 degrees Celsius, boiling point higher than 1050 degrees Celsius, 1000 degrees Celsius vapor pressure should be as low as possible.

3、在1000℃左右溫度下，不與玻璃發生化學反應。

3, at the temperature of 1000 degrees Celsius, not with the chemical reaction of the glass.

由于表面張力的增厚作用，即使短期被拉薄，隨后會在表面張力的作用下，縮小寬度，厚度回到平衡厚度。只有當玻璃的溫度下降到使玻璃的粘度迅速增大，而表面張力則增加不多，巨大地粘滯力使表面張力難以發揮作用，因此，當有拉邊器是，在強大的拉力下就可使玻璃變薄。

Due to the thickening of the surface tension, even if the short term is thin, and then will be in the role of surface tension, reduce the width, thickness back to the balance of thickness. Only when the glass temperature dropped to the glass viscosity increases rapidly, while the surface tension increase, huge viscous force of surface tension is difficult to play a role, therefore, when the edge roller is in strong tension can make the glass thinning.

本文由濟南合飛數控設備有限公司(滾壓復合機,開齒穿條機,開齒穿條一體機,穿條設備)整理提供